Gen2 Liberty steering stopped working
#1
Posted 27 March 2016 - 06:05 PM
Have had no issues with the steering, or warning of failure. But was working fine one drive then the next no power steering at all.
The belt is fine, tight, pump spins. Fluid levels good.
No weird noises etc. Just no PS.
Where you reckon I should start troubleshoot?
Is there any electrical components or just mechanical?
Thanks
Joel
Sent from my XT1092 using Tapatalk
#2
Posted 27 March 2016 - 06:18 PM
See if it's pumping any fluid
Just off the top of my head I'm fairly sure the gen 2 has no electrical components on the pump or rack, some Imprezas had a bypass on the pump
#3
Posted 27 March 2016 - 06:54 PM
Did it fail to work after a fresh startup (ignition on?).
Mine (Gen3) has done that in the past once. Ignition, start, no PS (PS light on).
Turn off, restart, all is fine.
I think it fails some sort of startup check. Though Rob's 'no elec on the system' note would preclude that in a gen2, if true.
#4
Posted 28 March 2016 - 08:28 AM
Sent from my XT1092 using Tapatalk
#5
Posted 28 March 2016 - 09:19 AM
yeh - sounds similar to what happened to me. Did it once, hasn't done it since. I checked fluid level straight away and it was fine.
#6
Posted 28 March 2016 - 09:43 PM
Bringing the revs up seems to make it worse as well.
Sent from my XT1092 using Tapatalk
#7
Posted 28 March 2016 - 09:54 PM
I had a poke through the gen3 wiring -- doesn't seem to be any electronics there, either - apart from pressure sensor.
Maybe there's a regulating valve or something that sometimes gets stuck, air getting into the system? Anyone know ?
My event was certainly distinct. No power steering, even after a couple of revs. Turn off, restart, all good.
#8
Posted 29 March 2016 - 06:42 AM
#9
Posted 29 March 2016 - 09:36 PM
Try swapping the pump over.
If I told you I was a compulsive liar, would you believe me?
#10
Posted 30 March 2016 - 07:05 PM
Sent from my XT1092 using Tapatalk
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users