Time to do it properly now, i want to connect my boost gauge positive wire to the headlights so it illuminates only when i turn my lights on, whats the way to go about this, which is the right wire. Any help thanks
Jono
Connecting boost gauge
Started by JonoTT, Jun 27 2019 10:31 AM
4 replies to this topic
#1
Posted 27 June 2019 - 10:31 AM
#2
Posted 27 June 2019 - 11:16 AM
use the dash illumination signal which goes to all the dash lights & radio, tap into it somewhere handy (my boost gauge is in driver's air vent, so I think I tapped off the fog-light switch illumination in the panel next to the steering wheel. They all illuminate with the headlights).
Wire 'V' is +12V, and 'BW' goes to the illumination module, which controls dash brightness. Your light needs to go between those.
light.jpg 125.67KB 1 downloads
Wire 'V' is +12V, and 'BW' goes to the illumination module, which controls dash brightness. Your light needs to go between those.
light.jpg 125.67KB 1 downloads
#3
Posted 27 June 2019 - 11:42 AM
I see, good diagram, will give it a go thanks Duncanm
#4
Posted 27 June 2019 - 06:00 PM
Can use the Accessory plug
Attached Files
Liberty B4 2002 BE5 Rev E 2.5L BITURBO TF035HL-14GXT E85
#5
Posted 27 June 2019 - 07:34 PM
Thanks Zanzarah, il look at both technics
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users