Is there supposed to be about a 5mm gap along the top of the window seal/plastic. It's not leaking at all, but it also doesn't budge when I give it push. It meets where the body curves off. Should have looked last cruise at others but I doubt its meant to be there. Only thing I can think of is that its had the seals redone in its life - it has been like it since I bought it.
Doesn't really bother me, just curious to know if anyone else has seen this, is it easy to fix.
Untitled-1.jpg 35.22KB
0 downloads
Window Seal - Gap along the top??
Started by TSG, Dec 14 2011 04:45 PM
4 replies to this topic
#1
Posted 14 December 2011 - 04:45 PM
#2
Posted 14 December 2011 - 05:14 PM
Pretty sure I know what your talking about, I asked the same question months ago... And the gap IS suppose to be there.
The gap that runs right along the side of the roof of the at just above the doors? Like a little gutter that ends up closing off at each end?
The gap that runs right along the side of the roof of the at just above the doors? Like a little gutter that ends up closing off at each end?
[03.SUBY]
#3
Posted 14 December 2011 - 05:34 PM
Yeah that is the one. Unless it was only done to some but not others. It is pretty much a gutter made with the seals..
#4
Posted 14 December 2011 - 05:55 PM
My outback has it, I didn't notice it for a while since when I bought it. Just looks strange to me.
[03.SUBY]
#5
Posted 14 December 2011 - 05:59 PM
Yeah its supposed to be there mate,all gen3's ive seen have it i think its just a rain gutter of sorts to try and stop water coming in the window
Doesnt work too well though lol
Doesnt work too well though lol
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users