Jump to content


Andyjs2

Member Since 30 Aug 2014
Offline Last Active May 20 2016 05:32 AM
-----

Topics I've Started

HID washer cover removal

23 November 2015 - 11:30 AM

Just thought I'd ask before I break these things

Looking to pop the little chrome covers off the HID washers to make them easy to paint, I've had a go, but feel like I'm gonna break them

Anyone done it before?

2008 GTB

Anyone tuned by All Drive Subaroo

30 September 2015 - 10:42 AM

Hey guys

In the process of a rebuild and retune by these guys

I've seen a lot of good word about their workmanship but have been struggling to find anything on their tuning

It's a 2008 spec.b GT if it makes a difference

Loose steering after ALK and springs

06 September 2015 - 04:07 PM

Alright, bear with me because this will be a little hard to explain
So since doing the ALK and STI springs in my 2008 liberty, I've noticed the steering feels... 'loose' I guess
Travelling at a normal speed (60+) and turning the wheel side to side (like a race car warming it's tyres) feels like there is almost a lag in the steering response, it's quite obvious
And also sometimes feels like the car is almost understanding when I throw it into a corner

Do I need a bump steer correction kit?

As far as I remember it didn't feel like this before the alk and springs

I'm also looking at whiteline steering rack bushes (for about $80 thought would be worth would be worth a shot)

Stencils

29 June 2015 - 08:59 AM

Does anyone here make stencils?
specifically I wanted a Mishimoto one for my new intercooler

Cheers

Heat wrap questions

09 June 2015 - 11:46 AM

Just looking for some info and general is for wrapping aftermarket headers+uppipe
Already decided to use the new style 'titanium' or 'vulcan' wrap

About to put a set of headers on, not to worried about the most likely minimal performance gains, but I was worried about the added heat that unprotected headers are gonna add... don't wanna overheat or melt anything important

First questions:
approximately how much will I need, 15m or should I bite the bullet and get 30m

1" or 2" (in my experience taping hockey sticks, thinner was better, but obviously doesn't go as far, same for heat wrap?

Wet it first?

And last of all
Is there any difference between buying from Australia and buying from Hong Kong? Is it all the same shit?
Mostly I've found you get what you pay for
($20 difference for a 15m roll)


Also if anyone has any extra tips I should know

Cheers guys