Hi everyone,
Recently upgraded to B4 2 Pots up front and changed to Hel Braided Brake lines, just wondering when i install the rear lines should I remove the solid piping between the two rubber lines and install the braided lines where the solid lines where? The lines look long enough just not sure... Btw Flare Spanners are awesome!
Cheers!
Myles.
Braided Brake Lines: Rear Fitament Gen3 Liberty
Started by Myles_91, Feb 01 2013 09:05 PM
brake lines braided brake hel
4 replies to this topic
#2
Posted 01 February 2013 - 09:34 PM
Sounds about right. Always use pipe spanners on brake lines!
I'll take a photo of my setup on the outback tomorrow to give you a rough idea.
I'll take a photo of my setup on the outback tomorrow to give you a rough idea.
#3
Posted 01 February 2013 - 09:58 PM
Cheers! I must take a break from car modifying after this!
Car: Subaru Liberty RX MY00 Sedan
Build Thread
#4
Posted 01 February 2013 - 11:12 PM
NO!
Gen3 and Gen4 with the multi link rear use a 6 piece line kit. Single line front, 2 lines per side rear. If you have a 4 line kit, you have the wrong kit.
Seen it so many times.........
Gen3 and Gen4 with the multi link rear use a 6 piece line kit. Single line front, 2 lines per side rear. If you have a 4 line kit, you have the wrong kit.
Seen it so many times.........
OEM+
#5
Posted 02 February 2013 - 09:30 AM
Ok no worries, I specified that I have a Gen 3 Liberty, they even called me to confirm... Strange...
Thanks for the help!
Thanks for the help!
Car: Subaru Liberty RX MY00 Sedan
Build Thread
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users