So pretty sure this is the 4th gen1 liberty build thread ive started.
I was just bored at work on thursday on gumtree and found it fairly cheap with blown piston rings, it was fairly close to work so i went and looked at it. drove home thinking about it and ended up stopping at a servo grabing a car railer and going and getting it that night.
did a compression test and sure enough #4 cylinder barely made a reading on the gauge.
after being screwed around by these cuntox's http://www.challengerauto.com.au
i sourced a bare long engine and set about putting it in.
annd thats what ive spent all weekend doing.
so heres some spec/mods:
92 Aus delivered RS:
WRX ej20 (98model rex)
td04 turbo
3" TBE with unknown muffler
GC8 FMIC
GFB atmo BOV
Turbosmart boost T
17" wheels
GC8 struts superlow king springs
Version4 STI 5spd
rear window roof spoiler
Legacy garnish
MOMO drift spec steering wheel
Future plans:
daily it hopefully and trailer it to wakefield and wsid and flog the fuckers out of it. Run a surge tank and external fuel pump, try tidy it up a bit.
Id love to say brembos 6spd coilovers and a built motor, but i think ive said that a few times before