Jump to content


L A R V E N

Member Since 21 Sep 2011
Offline Last Active Dec 15 2014 07:19 PM
-----

Posts I've Made

In Topic: MOVEMBER 2011

14 November 2011 - 11:05 PM

Posted Image

Its getting super soft - but itchy as!!! Keep up the good work boys...

In Topic: Negitive Boost Tank - DAMAGED

06 November 2011 - 04:16 PM

It works, the mounting brackets needed to be changed. But other then that its all good.... AZZA thanks for letting me use your welder. Scuba too thanks for getting the item to me so quick, LEGEND!

Just made it to the post office on time, the post office lady had to delay the driver so I could get this sent off in todays post :)


In Topic: Negitive Boost Tank - DAMAGED

03 November 2011 - 12:44 PM

scuba-roo helped me out with a tank from a gen2 mount brackets look
different But ill just weld the other ones on and should be sweet. Fingers crossed the tanks volume is the same. Find out on Friday....

In Topic: Negitive Boost Tank - DAMAGED

02 November 2011 - 05:00 AM

It won't have the vacuum capacity to fully open the ecv without the tank, also it uses vacuum to hold the 2ndry turbo IC valve closed, so that valve will open itself when it runs out of vacuum.

What it u do? get a bit too keen with the new engine conversion??

LOL, I wish I could say that but it was in a car park cross section the other car had right of way but I could see around the corner creeper half way and by that time, bang my, fault.? what can you do!

That makes sence about the evac. Car stumbles at 4000 - 4500 rpm boost fails.

In Topic: DIY: Rectify Light Steering

19 October 2011 - 08:45 PM


Chris your old etune is strange as mine sure does not have this...



I know right..! Lots of little things are so different...


shonkiest.


diy.








evah.



LOL - I know, but hey :blush:My next DIY post will be WAY BETTER and less on the shonky side...
BUT it does work, and there is so much more control...