Find content
Male
I was given a car hoist by my dad (long story) and have poured a slab and installed it. It is almost finished, except the electrical connections, which I am having a go at doing and then having an electrician check over to save some money and time.
The problem is that the schematic seems quite short on information for inputs pertaining to the hoist... I'm hoping someone here can provide the necessary information to finalise it ready for the electrician this week.
There is a cut off switch which I believe is SB3, that I can't find the correct numbers for.
The control solenoid on the pump needs to be connected also, but doesn't have numbers.
The neutral wire appears to need to be connected in a different location to the active?
There is 2 wires 07 and 09 that need to go from those numbers to the same numbers elsewhere in the circuit.
It looks like the motor is connected through the bottom breaker feed on the right.
And finally the locking solenoids need to be connected, but it isn't clear where they are connected either.
http://cloud.tapatal...218_094129.jpg?
http://cloud.tapatal...218_095213.jpg?
Hoist is a Torin Bigred 3.5t 2 Post lift model number QJY235D-E if that's of any use.
